Tile and Grout Cleaning
If you're looking for the best tile and grout cleaner, then you are on the right page.
Grout is a porous material that easily collects dirt and grime. Not to mention, this becomes a great breeding ground for mildew, mold and even bacteria.
This is very unhealthy!
Your grout can quickly look discolored and dirty but, even worse it can actually contain germs and mold. This is not the type of cleaning that can be taken care of by a simple mopping or spot cleaning.
If you want to truly reach the hidden dirt that lies deep within the pores of your grout lines. Here is our process for hard surfaces:
1. Vacuum/Sweep Floor- This is the first step to any of our cleanings. This step is crucial before we clean hard surfaces so we do not waste time going back over finished work for pieces of grime and dirt that may have been left in your finish.
2. Apply Cleaner and Agitate- After the area has been cleaned we will apply our heated cleaner and allow to dwell. All the areas will be agitated with a tile brush to loosen up any traffic or dirt in the lines and the plates.
3. Extract- This last step will be a heated flush and extraction of the wastewater and solutions from the tile surface to give it a professional look and finish to last a long time. Tile sealant will be applied per customer request.
Grout is a porous material that easily collects dirt and grime. Not to mention, this becomes a great breeding ground for mildew, mold and even bacteria.
This is very unhealthy!
Your grout can quickly look discolored and dirty but, even worse it can actually contain germs and mold. This is not the type of cleaning that can be taken care of by a simple mopping or spot cleaning.
If you want to truly reach the hidden dirt that lies deep within the pores of your grout lines. Here is our process for hard surfaces:
1. Vacuum/Sweep Floor- This is the first step to any of our cleanings. This step is crucial before we clean hard surfaces so we do not waste time going back over finished work for pieces of grime and dirt that may have been left in your finish.
2. Apply Cleaner and Agitate- After the area has been cleaned we will apply our heated cleaner and allow to dwell. All the areas will be agitated with a tile brush to loosen up any traffic or dirt in the lines and the plates.
3. Extract- This last step will be a heated flush and extraction of the wastewater and solutions from the tile surface to give it a professional look and finish to last a long time. Tile sealant will be applied per customer request.